Brake System qFoot Brake Your Mazda has power-assisted brakes that adjust automatically through normal use. If forcible entry is attempted, the system sounds the horn and flashes the hazard warning lights. Exhaust Gas in Enclosed Area: Running the engine inside an enclosed area, such as a garage, is dangerous. Maintenance and Care Owner Maintenance Power Steering Fluid qInspecting Power Steering Fluid Level. Should power-assist fail, you can stop by applying greater force than normal to the brake pedal. If not, the child could be seriously injured or even killed in an accident.
If any do apply, follow Schedule 2 Canada and Puerto Rico residents follow Schedule 2. Knowing Your Mazda Security System Mazda recommends that you affix them to the lower rear corner of the front door windows. The vehicle begins to vibrate excessively. Dialing a number on a cell phone while driving also ties-up the driver's hands. Be sure the vehicle is on a level surface. It could result in extensive engine damage.
If warmer air is desired at floor level, set the mode selector dial at the position and adjust the temperature control dial to maintain maximum. This increases the chance of paint chipping. Before this happens, repair the damage by using Mazda touch-up paint according to the instructions in this section. It may rupture or explode, causing serious injury. Exhaust gas, which contains poisonous carbon monoxide, could easily enter the cabin. The system is off when the ignition is off. This large family car was introduced by the Japanese manufacturer in 2002 and it is now at the third generation.
Reverse lights, Taillights Sedan 1. If the belt minder is long-term deactivated, the belt minder will not activate until it is restored at the Authorized Mazda Dealer. Setting the temperature to maximum high or low will not provide the desired temperature at a faster rate. Turning off the alarm Press any button on the transmitter. Press the rewind button to rewind. Remove the fuse block cover.
If you lose a key, an Authorized Mazda Dealer will reset the electronic codes of your remaining keys and immobilizer system. Should this happen, consult an Authorized Mazda Dealer as soon as possible. Adverse handling or unexpected tire failure could result in a serious accident. Leaving the lap portion of the belt fastened could cause damage to the seat belt, buckle and seatback. These may fit your vehicle, but they are not approved by Mazda for use with Mazda vehicles. Consult an Authorized Mazda Dealer if there is any need to remove or reinstall the front seats. Driving Your Mazda Switches and Controls Horn To sound the horn, press around the mark on the steering wheel.
Scan tuning Press the scan button to automatically sample strong stations. Then install the blade assembly in the reverse order of removal. Pull up on the trunk lid to make sure it is secure. Bring all transmitters to an Authorized Mazda Dealer when the electronic codes need to be reset. The shoulder belt should be worn across your shoulder properly, but never across the stomach area. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser exposure.
Always have an Authorized Mazda Dealer inspect the air bag systems after a collision. To prevent damage to the wiper blades, don't use gasoline, kerosene, paint thinner, or other solvents on or near them. Rear window defroster switch Mode selector dial Fan control dial This dial allows variable fan speeds. This could weaken or damage the tether or tether anchor and result in injury. Remove the jack container lid. Interior Comfort Interior Equipment Interior Lights. After that, the front air bags will not work again and must be replaced.
Grasp the buckle D and tongue C. Always inflate the tires to the correct pressure page 10-7. Start the engine of the booster vehicle and run it a few minutes. Inspect inflation pressures and condition of tires. Turn it clockwise for hot and counterclockwise for cold.
If it is still not retracting properly, have it inspected at an Authorized Mazda Dealer. Ask your doctor for specific recommendations. Long-term deactivation To deactivate the belt minder over the long term, consult an Authorized Mazda Dealer. If the lighter doesn't pop out within 30 seconds, remove it to prevent overheating. Damaged Front Seats: Driving with damaged front seats is dangerous. Turn the wing bolt counterclockwise. Press the scan button once again to cancel scan play.